Previous Index Next
Page 351
(previous) (Page 000351) (next)
 
320 THE BOY ELECTRICIAN

of sheet-brass according to the shape and dimensions shown
in Figure 265. The brass should be one-sixteenth of an
inch thick. The two projecting pieces at the top are bent
over at right angles so that they can be mounted on the

 

 

FIG. 264. —Details of the Floor of the Car.

under side of the car floor by small screws passing through
the holes. The holes which form the bearings for the ends
of the axles upon which the wheels are mounted should
be three inches apart. The bearings cannot be placed in

-..’

 

  

 

 
 

 

 

 

 

o
‘----_--- I
. a
' t
O 0 .
o : H— a ——>: ‘ atanmc :
3 g ,, . 1/01.: 0
: «— .9 __._.. :
O
F \ 6“ ;§

 

FIG. 265. —Details of the Bearing which supports the Wheel and Axle.

position on the under side of the car floor until the wheels
and axles are ready, but when this work is done, care
should be taken to see that they line up and come exactly
opposite to each other.

Previous Index Next